ASN logo
Last updated: 8 December 2021
Statuts:Enquête Officielle
Date:jeudi 21 décembre 1967
Heure:16:00 MST
Type/Sous-type:Silhouette image of generic DC3 model; specific model in this crash may look slightly different
Douglas C-47A-70-DL (DC-3C)
Compagnie:Frontier Airlines (FL)
Immatriculation: N65276
Numéro de série: 19202
Année de Fabrication: 1943
Heures de vol:49282
Moteurs: 2 Pratt & Whitney R-1830-92
Equipage:victimes: 2 / à bord: 2
Passagers:victimes: 0 / à bord: 0
Total:victimes: 2 / à bord: 2
Dégats de l'appareil: Perte Totale
Conséquences: Written off (damaged beyond repair)
Lieu de l'accident:Denver-Stapleton International Airport, CO (DEN) (   Etats-Unis d'Amérique)
Phase de vol: Au décollage (TOF)
Nature:Transport de Passagers Nat.
Aéroport de départ:Denver-Stapleton International Airport, CO (DEN/KDEN), Etats-Unis d'Amérique
Aéroport de destination:Scottsbluff County Airport, NE (BFF/KBFF), Etats-Unis d'Amérique
Numéro de vol:2610
Détails:
On December 21, 1967, Frontier Airlines had a backlog of more than 100,000 pounds of air freight which they were attempting to move during the busy pre-holiday period. Because of this, employees and equipment were pressed into service in a maximum effort to move the freight. Although Frontier did not use its DC-3 equipment in all-cargo operations, the passenger seats of N65276 were removed and the DC-3C was assigned to operate as all-cargo Flight 2610, from the Stapleton International Airport at Denver, Colorado to Rapid City, South Dakota, with an en route stop at Scottsbluff, Nebraska. About 1100 MST the aircraft was moved from the company hangar to the airport freight terminal for loading. About 1030, a Frontier radio communicator who knew how to prepare weight manifests was assigned to prepare the manifest for Flight 2610. He was given the operating and pit weight maximums for the aircraft. The dispatch office prepared a dispatch release for the flight. At 1100 and 1400 the employee called the freight office for specific loading information from which to execute the weight manifest. He was told both times that the information was not yet ready and would be furnished to him later. When this employee's
shift ended at 1430 he still had not received the information. He then went off duty, neglecting to inform his relief of the status of the situation.
In the meantime N65276 was being loaded. An air cargo service employee listed the cargo before it was loaded and tied down and later totalled its weight. No one engaged in the loading could recall that the cargo was placed in the aircraft according to any formal preloading schedule.
The first officer came to the air cargo office about the time the cargo listing was being totalled. He was asked if a weight manifest were needed and he replied, "No, we have our release, that's enough." When he reached the aircraft some of the loading remained to be done and he authorized the loaders to use some of the space left in the fuselage for an aisle to accommodate this cargo. The first officer bearded the aircraft, took the left pilot's seat and had started both engines by the time the captain
arrived and got aboard.
Just before the flight started to taxi out and while the captain was getting settled in his seat, a Frontier station agent began to remove the control battens and landing gear pins. When he started to remove a gear pin before the pilot signalled that hydraulic pressure on the gear was up, another station agent stopped him and took over. The latter agent subsequently stated that there was no batten on the left elevator and he did
not check the right one because it was customary to install the device on the left elevator when only one batten was used. He said that after he finished, he gave the crew a departure salute and that at no time did he see any of the controls move or any indication from the first officer that any of the controls were not movable.
Flight 2610, appropriately cleared, left the loading area at 1544 and about 1559 began takeoff using runway 35. Weather conditions were: scattered clouds at 5,000 feet, visibility 60 miles and the wind 270 degrees at 16 knots.
According to eyewitnesses, the takeoff appeared normal until after the aircraft became airborne. At this time it entered an increasingly steep climb attitude to an estimated deck angle of 50 to 60 degrees. About 300 feet above the surface, the aircraft rolled to its left and entered a steep nose-down left turning descent and crashed off the left side of the runway. The aircraft burst into flames at impact.

Probable Cause:

PROBABLE CAUSE: "The failure of the crew to perform a pre-takeoff control check resulting in takeoff with the elevators immobilized by a control batten."

Accident investigation:
cover
Investigating agency: NTSB
Status: Investigation completed
Duration: 90 days (3 months)
Accident number: NTSB File 1-0028
Download report: Final report


Opérations de secours
A major contributing factor in this accident were weaknesses in the airline operating system which were in part the result of a lack of management capability and depth to meet the problems associated with the airlines' current merger with Central Air Lines.

Photos

Add your photo of this accident or aircraft

Plan
Ce plan montre l'aéroport de départ ainsi que la supposée destination du vol. La ligne fixe reliant les deux aéroports n'est pas le plan de vol exact.
La distance entre Denver-Stapleton International Airport, CO et Scottsbluff County Airport, NE est de 255 km (159 miles).

Les informations ci-dessus ne représentent pas l'opinion de la 'Flight Safety Foundation' ou de 'Aviation Safety Network' sur les causes de l'accident. Ces informations prélimimaires sont basées sur les faits tel qu'ils sont connus à ce jour.
languages: languages

Share